General International DP2001 Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 13)

English

150326

8. Clean out the tapered hole in the chuck (K, g 2 & 3), removing any

grease, anti-rust coating or dirt you nd.

9. Clean grease, coating and dirt from the tapered spindle tip with a clean

cloth.

10. Open the chuck's jaws as far as they will go so they are fully retracted

into the chuck.

11. Push the chuck up on the spindle as far as possible. Lightly tap the

lower end of the chuck with a piece of wood to ensure the chuck ts

tightly on the spindle.

12. Install an M5 x 12 pan head screw from the inside of the pulley cover

through the hole and attach the knob (X, g 3) to the outside.

13. Clamp the chuck safety guard (J, g 3) to the lower exposed part of the

quill tube. Do not over-tighten.

LASER BATTERIES

1. Locate the laser switch (S, g 3) on the left side of the head assembly.

2. Press the tab located below the laser switch (g 4) and raise the cover.

3. Insert 2 "AA" batteries, oriented in the directions indicated.

4. Close the switch cover.

CAUTION: Remove the laser light batteries when the tool is to be

stored without use for a few days or more. If left in position, the batteries

might leak and damage the laser light assembly. Damage due to leaking

batteries is not covered under the warranty.

OPERATING INSTRUCTIONS

WARNING! Before using this machine, the operator should carefully

read over this operation manual and acquaint himself with the

construction, controls and drive system of the drill press.

SET THE SPEED

1. Open the belt & pulley cover (U, g 2 & 3) and choose the best speed

for the drilling operation planned and install the belt in the correct

position on the pulleys to produce that speed.

WARNING! Be sure the drill press is turned off and unplugged when

the belt & pulley cover is open and you have your hands in that area.

2. To move the belt, loosen the belt tension lock knob (Y, g 3) on the right

side of the head assembly, and let the motor pivot forward so that it

reduces the distance between the drive (motor) pulley and the spindle

pulley.

3. Place the belt on the two pulleys according to the needed spindle

speed.

4. Re-tension the belt when it is set in position by pivoting the motor away

from the spindle (front) end of the drill press head and re-tighten the belt

tension lock knob.

5. Close the cover

rpm: 620 tr/min

spindle

broche

motor

moteur

rpm: 1100 tr/min

spindle

broche

motor

moteur

rpm: 1720 tr/min

spindle

broche

motor

moteur

rpm: 2340 tr/min

spindle

broche

motor

moteur

rpm: 3100 tr/min

spindle

broche

motor

moteur

DP2001 belt spindle label

100 x 40 mm R=2

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

General International DP2001 Gebrauchs- und Pflegehandbuch Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge General International DP2001