General International DP2001 Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 10)

English

2. MAKE SURE YOUR FINGERS

do not contact the terminals of the power cord plug when plugging in or

unplugging the saw.

3. GROUNDED TOOLS MUST BE PLUGGED INTO AN OUTLET THAT

ITSELF IS PROPERLY INSTALLED AND GROUNDED.

Grounding provides a low-resistance path to carry electricity to ground

away from the operator, should the tool malfunction electrically.

4. DO NOT ABUSE THE CORD.

Never carry your tool by the cord or pull on the cord to unplug it.

Protect the cord from potential sources of damage: heat, oil & solvents,

sharp edges, or moving parts. Replace damaged cords immediately.

5. WHEN WORKING OUTDOORS, USE AN OUTDOOR-RATED

EXTENSION CORD.

An extension cord rated for outdoor use must be marked “W-A” or “W”.

6. THIS TOOL IS FOR INDOOR USE ONLY.

Do not expose electrical power tools to moisture. Rain or wet

conditions can cause water to enter the tool and lead to electric shock.

7. FOLLOW ALL LOCALLY APPLICABLE WIRING CODES

and recommended electrical connections to prevent shock or

electrocution.

GROUNDING INSTRUCTIONS

In the event of an electrical malfunction or short circuit, grounding reduces

the risk of electric shock. The motor of this machine is wired for 120 V

single phase operation and is equipped with a 3-conductor cord and a

3-prong grounding plug to t a grounded type receptacle B. Do not remove

the 3rd prong (grounding pin) to make it t into an old 2-hole wall socket

or extension cord. If an adaptor plug is used C, it must be attached to the

metal screw of the receptacle.

NOTE: The use of an adaptor plug is illegal in some areas, including

Canada. Check your local codes. If you have any doubts or if the

supplied plug does not correspond to your electrical outlet, consult a

qualied electrician before proceeding.

EXTENSION CORDS

If you nd it necessary to use an extension cord with your machine, use

only 3-wire extension cords that have 3-prong grounding plug and a

matching 3-pole receptacle that accepts the tool’s plug. Repair or replace a

damaged extension cord or plug immediately.

Make sure the cord rating is suitable for the amperage listed on the motor

I.D. plate. An undersized cord will cause a drop in line voltage resulting in

loss of power and overheating. The accompanying chart shows the correct

size extension cord to be used based on cord length and motor I.D. plate

amp rating.

Total Extension Cord Length

Amp Rating

Feet Meters Feet Meters Feet Meters Feet Meters

25 8 50 15 100 30 125 40

3-10 amp 18 ga. 16 ga. 14 ga. 14 ga.

10.1 - 12 amp 16 ga. 16 ga. 14 ga. 14 ga.

12.1 - 16 amp 14 ga. 12 ga. Not Recommended

Use only UL or CSA approved extension cords

WARNING! Do not allow familiarity with your tool to make your

careless. Remember that a careless fraction of a second is sufcient to

inict severe injury.

IMPORTANT: The warnings, cautions and instructions detailed in this

manual cannot cover all possible conditions and situations that occur. It

must be understood by the operator that common sense and caution are

factors that cannot be built into this product, but must be supplied by the

operator.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

General International DP2001 Gebrauchs- und Pflegehandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Elektrowerkzeuge General International DP2001